Introduction and working principle of the machine
Powder coating systems are ThinkLink company launched one of the series. The machine manufacturer specialized services in the canning of spray cans weld overlay technique. I learn that the adoption of a number of foreign advanced powder coating covering technology, makes the machine structure, high reliability, easy operation, wide applicability, cost-effective. It uses a lot of import control components, such as Japan SMC pneumatic components, Omron PLC programmable controller and touch control terminals and other components, making the system more stable and reliable.
YGZD-600B is the use of electrostatic powder coating machine powder coating on the plastic cans weld, the oven heating to melt the solid powder after drying in the weld to form a layer of plastic protective film (polyester or epoxy). Since the electrostatic powder spraying in accordance with the principle of adsorption specific shape of the weld is completely and uniformly cover the weld surface of the burr and low, so the weld can be well protected from corrosion of the contents; the same time, plastic powder of various chemical solvents and food inside of sulfur, acid, high protein are highly resistant to corrosion, making the powder coating for a variety of different content; also because excess powder after powder coating using recycling, re-the principle of use, the powder utilization, is the best choice to protect the weld.
Powder coating machine is three cans production line in an important part of the market, highly praised by domestic and foreign customers, is a good canning equipment. Nanlong Machinery is committed to providing our customers the highest quality canning equipment, develop the best solution.
Machine structure
·Powder delivery, injection system.
·Powder recovery circulatory system.
·High voltage electrostatic system.
·Circuit control system: PLC control system and contains the human-machine interface operating systems.
·Pneumatic control system.
Technical parameters
Spray (transmission) speed | 5—60 m/min |
Yield | 50—500 can/min |
Can Diameter | Φ52—Φ280 mm |
Can Height | 50—300 mm |
Powder type | Polyester (Thermoplastic), epoxy curing powder type (heatset) |
Powder particle volume | 98% Less than 90 microns |
Cover width | 8—14 mm Recommended width:10mm |
Cover thickness | Cold spray Max: 150 microns, thermal spraying Max: 300 microns |
Maximum voltage electrostatic | 100 KV (Adjustable) |
Pink bucket capacity plot | Total 40 L |
Compressed Air | 0.4--0.5Mpa 0.4-0.6 m3/min Relative humidity<40% |
Supply Voltage | Single-phase 220V 50Hz |
Total power | 1.5 Kw(Free air compressor power) |
Host Dimension (L × W × H) | 850×800×2250 mm |
Total weight | Approximately 500 Kg |
Comment on loading...
|